English Deutsch French Español Italiano
Home | Documenti | Negozio in linea | Immagini & rapporti | Supporto
Home » Catalogo » Kit Antenne Yagi » DP4001R Carrello | Cassa
Categorie
 Kit Antenne Yagi
 Servizio di assemblaggio
 Antenne filari
 Pali in fibra di vetro
 Mast in alluminio
 Accessori ancoraggio
 Accessori per antenne
 Pezzi di ricambio
Carrello
Il suo carrello è vuoto.
Valute  
DISTRIBUTORE AMERICANO
Se siete sul continente americano visiti il nostro distributore per il Canada & S.U.A.
www.spiderbeam.us
40m Add-On Dipole for PORTABLE Spiderbeam Yagis
40m Add-On Dipole for PORTABLE Spiderbeam Yagis

This version is pre-assembled and ready to install on a Portable Version of a Spiderbeam Yagi. (Balun not included.)

The 40m dipole extends the coverage of most Spiderbeam Yagi Antennas to include the 40m band. It may be added on to most existing Spiderbeam Yagi antennas, or ordered together with a new antenna. The dipole is rotated 90 degrees to the other wire elements.

Both sides of the boom are extended by one additional fiberglass tube, increasing the turning radius from 5 meters (16 ft.) to 6 meters (19.2 ft.).
Each end of the dipole is capacity-loaded using two wires tied back to the side spreaders.

Content:
- 2 Fiberglass segments (PORTABLE Version / 35mm diameter)
- Wireman CQ-532 Copperweld Wire
- Enamel-Insulated Copper Wire 1.5mm dia.
- Special Coil Form
- Heat-Shrink tubing with hot-melt-glue inside
- Polyethylene Insulators, black, UV-resistant
- M6 Tubular Solder Lugs, galvanized and tinned
- PVDF Monofil Line, 1mm diammeter (UV-resistant)
- Wire-Ties (UV-resistant)
- Plastic spool (20cm Diameter)
- 2 Stainless Steel Hose-Clamps
- Flat Rubber Strip (UV-resistant)

The dipole may be connected to the Spiderbeam’s existing balun and used with the same feedline as the other bands, or used with a separate feedline and balun.
When using only one balun, the forward gain and front-to-back ratio for the higher bands are not affected, but the front-to-side ratio is reduced, especially on 15m.
The (optional) balun is not included with the dipole and must be ordered separately when 2-balun configuration is desired.
The balun is available either in kit form or pre-assembled and ready to install.


Feel free to download the SWR curves here.

NOTE: Not compatible with the WARC Spiderbeam Yagis.



disponibile su shop.spiderbeam.com »
301: Potete trovare questo prodotto qui nel nuovo negozio - https://shop.spiderbeam.com/en/shop/40m-add-on-dipole-for-portable-spiderbeam-yagis-1637 »


Condizioni commerciali | Rinuncia | Protezione dati | Consegna | Ritorna | Pagamento | Contatto | 

Site Encrypted by GeoTrustSSL Secure Credit Card Payments by Saferpay Site Verfied by SiteLock

IBAN International Bank Transfer Master Card PayPal Homepage-Sicherheit

Website by: OCTIC

Parse Time: 0.035s